Structural Fabrication
In-house CNC laser cutting, bending, punching, shearing and welding produce the structural steel, tanks, platforms and ductwork that form each system's frame.
Capabilities
Fabrication, robotics and controls under one roof
OMJX operates a 35,000+ ㎡ manufacturing base across 9 workshop bays in Yancheng, Jiangsu, integrating structural fabrication, process equipment assembly, robotics integration and field installation.
1996
Founded
Nearly three decades engineering coating and automation systems.
35,000+ ㎡
Manufacturing base
Integrated fabrication and assembly campus in Yancheng, Jiangsu.
9
Workshop bays
Dedicated bays for fabrication, assembly, wiring and testing.
CNC cutting & forming
Fabrication capability
In-house laser cutting, bending, punching, shearing and welding.
Process Equipment Assembly
Pretreatment tanks, spray booths, curing ovens and VOC treatment modules are pre-assembled and tested across nine dedicated workshop bays before shipment.
Robotics & Controls Integration
Robot arm selection, electrostatic applicator integration and line control programming are engineered to each part family's geometry and cycle time.
Installation & Commissioning
OMJX field teams install, wire and commission each system on-site, verifying performance against the agreed process specification before handover.
Engineering Process
How an OMJX project comes together
From initial requirements review to on-site commissioning, every system follows a consistent engineering workflow.
- 01
Requirements review
Our engineers review your part geometry, throughput, coating specification and plant layout constraints.
- 02
System configuration
A non-standard line configuration is proposed, combining pretreatment, application, conveying and environmental control modules to fit your process.
- 03
Fabrication & assembly
Structural steel, tanks, ductwork and control panels are fabricated and pre-assembled across our workshop bays.
- 04
Installation & commissioning
OMJX teams install, wire and commission the system on-site, then hand over documented operating procedures.
Discuss your coating or automation project
Share your process requirements and our engineers will follow up with a configured system proposal.